Content: 0.5 Liter (€19.80* / 1 Liter)
6005272
Plastic fabric dark gray
Dark grey plastic mesh.
Price per m.
• mesh size: 3 mm
• rolls height: 100 cm
• resistant, stable and frost-resistant
• Material: HDPE
V000014
American stainless steel slide, available in 4 different length
out of stainless steel
6000531
Bison hive strap
Click here for the product video: https://www.youtube.com/shorts/oTsszidevcE • Strap width 3 cm• Strap length 3.5 m• very stable design, anchor belt• sufficient for magazines up to 4 frames
6005276
Diffusion cover film (price per metre)
The diffusion film is an element that improves the climatic conditions within the hive.
- Allows moisture to be dissipated
- Stable and durable
- Easy to remove
- Improved control: The crystal-clear properties also make it easier to observe and handle in the beekeeping business.
The film is inserted in such a way that there is a minimum gap (0.5–1 mm) between the
foil and edges to allow additional diffusion upwards.
It was developed at the University of Innsbruck to strike a balance between
moisture management and thermal insulation.
The film can be combined with other innovative materials such as reflective fleeces.
Roll width: 500 mm
6005271
Galvanized wire mesh as fabric (metre, price per m)
Galvanized wire mesh as fabric by the meter.
Price per meter.
• Mesh size: 2. 8 mm
• Roller height: 100 cm
6005274
Plastic cover 50 x 50 cm
To lay between hive cover and top super to prevent cover from sticking to the frames
6001371
Velutina Trap mad of plastic
The BeeVital hornet trap is highly selective. Only hornets remain trapped!
Insects, bees and others can easily exit through the small holes at the bottom or sides of the trap.
The insects are never in contact with the attractant (important for the sanitary aspect depending on the attractant).
The hornet stay alive for a certain time and attract other hornets with their pheromones !
The hornets attracted by the attractant follow the light in the trap and remain in the collection containers.
Please note that when using the trap, the local species protection regulations applicable in the region must be observed. If necessary, the trap must be checked daily for bycatch and, if present, this must be released in accordance with the regulations applicable in the region.
The VelutinaTrap was made to capture the invasive species vespa velutina, while allowing other insects and bees to exit without difficulty.
Efficient: Hornets confined in the trap emit pheromones, luring additional hornets, enhancing the trap's effectiveness.
Hygienic: Insects never come into contact with the attractant, ensuring a clean and sanitary trapping process.
When to use:
- For the capture of fertilized hornet queens (foundresses), very early in spring, in temperate regions already in mid-February.
- Since the trap is highly selective, you can leave it in place year-round to capture the hornet workers as well.
- In fall, for the capture of fertilized hornet queens, in most regions from October.
6005000
Beginners kit
Set contains:
• smoker (no. 6001347)
• smoker tobacco (no. 6001358)
• lighter cubes (no. 6001350)
• beekeeper jacket (please advice your size!)
• leather gloves (please adivce your size!)
• bee brush (no. 6001214)
• hive tool (no. 6001202)
You can enter the sizes on the cart page in the comments field!
6005270
Wire fabric stainless steel (metre, price per m)
Stainless steel wire mesh by the metre.
Price per meter.
- Mesh size: 2. 5 mm
- Wire thickness: 0. 5 mm
- Roll height: 48. 5 cm
6001172
Propolis screen, 500 x 420 mm
Size: 510 x 415 mm. Made of flexible plastic, especially for propolis harvesting.
The grid is placed on the uppermost frames. When it is cushioned, it is placed in the freezer. The propolis can then be easily broken off. With a grating you can harvest up to 100 g of propolis.
However, the yield depends on bee breed, location, type of prey, weather and many more.
6005375
Brood Body temperature sensor ApiBrood-CR3
Tethered expansion sensor for hive scale ApiGraph3.0
How healthy is my bee company? The sensor measures the temperature inside the brood body – an important indicator for the bee health and the brood activity of the queen.
Technical details:
• Decay 0,1 °C, cable length 1,5 m
• Cable sensor with stainless steel detector cover
• Access to the hive scale or extension cable EasyLoad-CR3
6001372
VelutTractive 500ml for Hornet Trap
Original BeeVital attractant for Velutina trap, which consists of natural, sweet substances.
The insects do not come into contact with the attractant in the trap.
For the hornet trap against the Asian Hornet Vespa Velutina.
6005351
Nicot palet for 2 hives
Size: 960 x 530 mm
Height: 150 mm
Made of weather-resistant plastic
6005371
Charging and extension cable EasyLoad-CR3
Extension cable for the red charging- and extension connector (ApiGraph3.0)
Small cable – big relief!
This cable makes the red charging- and extension connector accessible from outside. So it is possible to charge the hive scale or to install the brood body sensor without taking of the hive with the bee company.
6001373
Velutina Trap Pro with Alu weather protection
The new Velutina Trap Pro is a live trap for catching the Asian hornet, Vespa Velutina. Other insects can escape or be released from this trap. The European hornet is too big for this trap and therefore cannot be caught.
The trap consists of:
• An extra-large plastic collection container (5 liters volume) that allows plenty of free space for captured hornets, incl. Inlet hopper and bait container with float.
• To ensure that the collection container does not heat up under sunlight, it is protected by a wood panel.
• Aluminium weather protection with suspension
As an attractant, we recommend a mixture of 1/3 beer, fruit juice and sweet wine.
+++ IMPORTANT NOTE: +++
Please do not use sugar water as an attractant, as this will lure bees into the trap!
V000025
Rähmchenhalter für Holzbeuten
Material: Edelstahl
Wandstärke der Beute: max. 26 mm
Kapazität: bis zu 3 Rähmchen
Gefertigt aus Ø 8 mm Edelstahldraht, mit angeschweißten Edelstahllaschen
6005373
Solarpanel SolarLoad-CR3
Autarkic electric power supply for hive scale ApiGraph3.0
Use the energy of the sun! A reliably solution to enable an uninterruptible operation even with a high data transfer and an elevated power consumption.
ATTENTION: to use it together with a tethered expansion sensor you need the distribution cable (no. 6005374).
6001374
Crabro selection adapters for Velutina Trap - 5 pcs.
Crabro selection adapters are inserted into the entry holes of our Velutina trap to reduce the diameter.
6000718
Distance rolls
For frames without Hoffmann side bar.
two Distance rolls have to be driven in at each side.
For 10mm distance with pin
Material:plastic
In neutral colour
Pack with 100 pcs.
6005350
Nicot Palet for 1 hive
Size: 440 x 530 mm
Height: 150 mm
Made of weather-resistant plastic.
6005379
USB-Powerbank FlexLoad
Mobile battery to reload the hive scale ApiGraph3.0 at the place of action
Reload the hive scale at each place! The powerband hast to be reloaded at home with a USB-power supply (e.g. Power Load). After that you can reload your hive scale within 4 hours with this power.
Recommended to it: With the extension cable EasyLoad-CR3 (no. 6005371) the charging access is accessible from outside.
6005370
Hive scale ApiGraph3.0
High-tech solution to supervise your bee colonies.Here you will find product videos: https://www.youtube.com/results?search_query=wolf+waagenDo you always supervise your bees? With the hive scale ApiGraph4.0 you can see the weight course and the temperature outside the hive. With optional expansion sensors you can see even more details. You will get all the information through the mobile network with the Wolf SIM-Card. With the use of the hive scale you can optimise your working so that you are able to earn more honey and have less loss of bee colonies during the year.The Basic set contains:• Baring plate 51 x 43 cm fits for example for Zander or DNM-hives• Universal mobile network aerial with a magnetic foot• USB- charging cable CR3, battery will be fully filled by delivery• Pair of keys (same locking system for umpteen hive scales)• With Wolf Sim card Europe-wide ready for use immediatelyOptional expansion products (they aren’t contained in the set!)• Temperature/ humidity – sensor ApiClimate-RF3 (no. 6005377)• Rainfall sensor ApiRain-RF3 (no. 6005376)• Brood Body temperature sensor ApiBrood-CR3 (no. 6005375)• Anemometer ApiWind-RF3 (no . 6005378)PLEASE NOTICE:We want to point the running costs out (with yearly payoff):server charge 24, - € per year (incl. sales tax) independent to the number of scale. Wolf SIM card (optional) 15, - € per year and card incl. data communication, plus 0,09 € per alarm SMS
6005378
Anemometer ApiWind-RF3
Funk expansion sensor for hive scale ApiGraph3.0
A low breeze or a strong squall? Stay optimally informed about the wind conditions at your bee hive. So you can estimate if your hives need for example more shelter.
Technical details:
• Decay 0,5 m/s
• Radio range up to 3 m
• Up to 1 year attended time with 2 AA-Batterie (Mignon)
• Flexible expansion able due to wireless link connection
6005372
Extension board ApiMAX-51
Increase for ApiGraph3.0 up to 51 x 51 cm (Dadant o. Segeberger)
Perfect for big hives!
The Extension board is put on the standard baring plate of the hive scale ApiGraph3.0. Guide strip make it fit accurate.
6005277
Reflective fleece (price per metre)
The reflective fleece is presented as a cost-efficient and effective supplement that optimises the internal climate of the hive.
The fleece is designed in such a way that thermal radiation is reflected back into the hive space and a micro-perforation allows diffusion at the same time, which increases overall energy efficiency. The fleece is ideally suited for the construction of insulating covers, insulating bulkheads, insulating aprons and insulating floor inserts.
Application on the Varroa cup:
It is recommended to use reflective fleece in combination with a diffusion foil (masking foil), e.g. on the Varroa cup, in order to minimise heat loss through the hive bottom.
Practical advantages:
The fleece is easy to handle and helps to keep the internal climate of the hive stable, especially during colder seasons.
Benefits for bees and beekeepers:
Energy saving: The reflection fleece helps to reduce the heating power of the bees, which saves their energy.
Roll width: 500 mm
6005377
Temperature / Humidity-sensor ApiClimate-RF3
Funk expansion sensor for hive scale ApiGraph3.0
Which fling terms are outside the hive? From the measured data (temperature- /humidity measure) you can draw conclusions about the accumulative activity and the effectivity of your varroa attendance.
Technical details:
• Decay 0,1 °C, 1% r.H.
• Radio range up to 3 m
• Up to 1 year attended time with 2 AA-Batterie (Mignon)
• Flexible expansion able due to wireless link connection
6005100
Professional hive lifter (AWD)
Professional hive lifter with electric drive, both wheels and lifting device
The hive lifter can lift 100 kg from 0 cm to 107 cm height quickly and without any problems. The device only needs 11 seconds to do this. Manual loading into your transporter or onto the trailer of the device itself can now also be saved, as this hive lifter is driven by a chain and is thus able to lift itself up. All you have to do is push it manually into the hold or onto the loading area.
The hive lifter has particularly wide jaws and can be used for both wooden and polystyrene hives due to its large surface.
• Maximum lifting height: 107 cm
• Measurements: 167 cm x 68.5 cm x 48 cm
• weight: 52,5 kg
• Speed: 6,5 km/h
• Maximum lifting weight: 100 kg
• Working time with one charge: 4 h
• Charging time: 6 h
Scope of delivery:
Hive lifter and charger
Available accessories:
spare battery